Hey everyone,
I'm looking for a closed-loop motor, where I can set the RPM and the motor works out how to reach the set point.
I considered using a standard DC motor with a hall effect sensor as feedback, but I'm certain that there must be an off-the-shelf unit with the same functionality...
Hey,
I've got a medical device prototype with a complex tubing system for drug delivery.
I've used various different tube-to-tube and syringe-to-tube adapters in the system, so it's made up of various different pieces that need to be put together before use.
I would like to replicate the tubing...
Hi everyone,
I'm building a prototype that uses a power supply which is divided into 4 separate 24V supplies.
They do not share a common ground. I shorted all of their grounds, but it's really messy with lots wires running all over the device.
In order to keep everything tidy I printed a part to...
Hey,
I'm looking for a tube to fit s system with barbs like this one:
which fits 1/8 inch ID tubing.
I need it to bend easily and also not collapse under a vacuum.
The system is for medical purposes.
Any recommendations?
Hello,
I'm designing a foam delivery system, and I need to keep it under a certain pressure.
I'd like to model the foam as a viscous fluid in order to get a rough estimate of pressure in the tubing system as a function of fluid velocity, viscosity and pipe diameter.
Could anyone point me in the...
Hello all,
I'm looking for recommendations for a 3D printer based on the following criteria:
- The printed parts are to be used in a medical device prototype.
- The printed parts will be used in pre-clinical trials, so any important regulatory issues such as material used could be meaningful.
-...
Hello all,
As said in the title, I am searching for a filter that connects to a Luer component.
For example:
https://www.hplcvials.com/d/pic/hplc-syringe-filter/five1-1.jpg
The problem is that I'm looking for one with a pore size of at least a 5 micro-meter, hopefully larger.
Can anyone assist...
Hello all,
I'd like to connect two tubes as follows:
Tube 1 -
ID = 3.5mm
OD = 6.8mm
Tube 2 -
ID = 18.0mm
OD = 21.1mm
IS there a standard connector that can be used to connect these tubes?
I'm building a prototype and have considered 3D printing a connector and fastening the tubes to it with...
Hi,
I'm a new engineer working on a prototype with a circuit including the following components:
PLC (24V)
Servo Motor (separate channel, 5V)
Push Button ,fed by the same 24V and fed to the PLC.
I've written a very basic code, where I want the servo to perform a certain pattern of movement...
