Dear community,
I have two chambers that are separated by a door. One chamber has an initial temperature of 450C and the other 100C. For the sake of simplicity we can assume that both have the same volume (approx. 1 m^3)
If we assume that there isn't a pressure gradient between the two...
Dear community,
I am planing to use friction wheels on my current design but before starting the selection of the elements, I was reading a little bit about them. I found online the following information:
I would like to ask if you agree with the statement of the last bullet point. In my...
Hello everyone,
I am currently trying to project a curve on an unbended metal sheet part. I am following the following steps:
1) Design the metal sheet using SB Contour flange
2) Unbend the geometry
3) Projecting the sketch on the unbended surface
4) Bending again
The problem is that I am not...
