Hello everyone.
I am practicing with the Tolerance StackUp theme to determine the GAP of the following image:
I have three proposals so far of the routes that can be used, however I would like to know your opinion to see if my deductions can be correct (I share my 3 proposals below) Any...
Hello everyone.
I'm working on Inventor (I know the forum is not for this software but it is for Autodesk)
I wanted to know if any of you know how I can select this face to generate this gap in the tolerance analysis environment
Left is my reality, right is my expectation
Hello to the entire forum, again I contact you to answer a question about an exercise that I am working on, I would like you to support me by verifying my answers and give me your opinion with number 5 and 6.
The question is:
"Relative to Datum Feature" A ", which Geometric characteristic is...
A question, do any of you know where I can get this book to read online? (I don't know if this type of question is allowed, so I apologize if not)
Greetings!
Hello everyone, could you help me by guiding me in solving the following 2 questions, I am currently studying the subject of GDTS on my own on the internet and I have no one to advise me with my questions
Thanks to everyone for your support!
What is the location tolerance for the 18 holes...
