Search results for query: *

Hi Friends, I have a doubt in Teamcenter - Project Manager - INACTIVE Projects. I have created a item in a project. Later the projects is marked to Inactive. Users not having access for that project will have Read-only access. As a group member in that Inactive Project, i can...

Dear Friends, Can anyone suggest, is any ASME book available for standards on Sheetmetal? or any reference book please.

Dear All, I need to know the best design software for - Mechanical Fabrication design. How is the field of fabrication design for next 20yrs. Can anyone help in this regard...!! Thankyou.

Hi Friends, Need a help in reg. Two Datum Features, Single Datum Axis. Is my assumption correct? Thanks.

thread1103-468608 Dear All, Had a doubt in Three segment composite tolerance, In this, for B Size limit - (73.72 - 73.86 (MMC)) for C Size limit - (13.52 (MMC) - 13.66) If my B Size = 73.8 & C = 13.6, which got after machining. Will there be shift in Hole axis? SME's kindly...

Dear All, Have a doubt Composite Position Tolerance, In this PLTZF, It's given B(M), this secondary datum is referenced for Axis. Does giving B(M), can vary the positioning of Hole pattern? If the DATUM B, is given with position tolerance, it would make a shift in...

Dear All, Have a Doubt in selection of Tolerance, Here, CTQ - Critical to quality. What is COP & COPQ? How it will influence in selection of Tolerance value? Kindly help in this regard.

Dear All, Have a doubt in using MMC principle used in Profile Controls, Can i know, how the value is calculated? - Ashwa.

Dear All, Have a doubt in Profile Tolerance, The 2nd part of Callout leads to Pattern located by composite profile tolerance, What does the 1st part 0.1 INDIVIDUALLY refer? Sorry, if it's a already asked query. - Ashwa.

Dear All, Having a basic doubt in Cylindricity, Here, Max. limit is 1.000 + 0.010 + 0.001(Cylindricity) = 1.011 Min. limit is 1.000 - 0.010 - 0.001 (Cylindricity) = 0.989. Is this correct? Pl. clarify.

Hai All, In the drg, the Hole is Located using Position Tolerance 0.010 at MMC, which is stationary. Next, the Hole Axis will have to Orient and Float at 0.002 but within 0.010 at MMC. My Question is, Why we need a Parallelism tolerance here & any purpose? If the Hole Axis will have...

Hai, I have a doubt in basic selection of Tolerance for a part. Tolerance is classified into FIT, FORM & FUNCTIONAL. for, FIT we can select by means of using FIT CHART. FUNCTIONAL TOLERANCE can be attained by STACK-UP ANALYSIS. How, FORM TOLERANCE is selected? also by STACK-UP...