Hi all,
I am looking for an international standard that suggests finishing coat colors (RAL numbers) for various equipment/piping in an oil and gas site. Is there any standard or is it the client spec only?
Kind regards,
Hi Gents,
Can you introduce a reference to specify the material for tubes in aircoolers?
In specific, what could be the proper material for tubes in an air cooler as a steam condenser (steam inlet and condensate outlet)?
Thanks
Hello All,
In the basic phase of a project, thermal and sizing design of shell and tube heat exchangers shall be done or the responsibility can be given to the vendo?
Hi Gents,
What could be the reason and solution for the corrosion in the below photo?
The wall of electric equipment, nameplate, and lock all are 316L (material certificates approved valid for 1.4401/1.4404) and the weld filler is 316Lsi(1.4430).
The equipment is just received on-site and not...
Hi all,
In Waste Plastic Pyrolysis, we faced severe corrosion problems in our Pyrolysis Reactor.
Operating condition:
-Feed: Mix of waste plastic
-Temperaure: up to max 850°C
-5hours Pyrolysis, 2-3 hours regeneration (combusion+deckocking)
-Time by time cool down to room temperature for...
Hello All,
For one of our projects, we need to select proper material for a pipe containing melt plastic contaminated with Bromide and Chloride. Following is the operating condition:
Design pressure: 50 bar
Design Temperature: 420 °C
The contamination of bromide and chloride is not clear yet...
Hello all,
For a pipe between Reactor and Extruder, we need to select a block valve. This valve blocks the line for cleaning. Do you have any idea which kind of block valve best suits? Please share the manufacturer if you have experience working with them.
Design Temperature: 420°C
Design...
Hello all,
To install a replacement vertical vessel on existing anchor bolts, vendor suggested that legs be split into two parts. The lower part will be delivered to the site sooner to be installed and then later the reactor will be welded to it.
The suggested welding method is as below...
Hi all,
for one of our projects, we need to perform detailed engineering for the Tank API650 design.
What is your suggested software for the calculations? Is there any excel sheet for the calculations?
Hello all,
Bidder stated in the proposal that Ferrite testing will be carried out only on the welds of duplex spools. Why not for the other spools including SS316 and 304L?
Hi all,
In a project, we have bout a small 1" globe valve. The material certificates that we received for this valve are very old and backs to 2015. Could it be acceptable?
Generally what is the approach, shall the vendor issue a material certificate for each purchase separately or if they have...
Hi all,
Inspection shows a crack in the shell of the deaerator at the weld of the top platform support. Condition is as below.
-Deaerator, 3.5barg, SS304L, 10 yeas old
-4 top platform support leg, track on only one of them at 12 o'clock position.
-Please see the photo. we have marked the...
In ISO 15614, there are two tables for material thickness in welding. One is for butt weld, the other for fillet weld.
Do you think the following joints are butt weld or fillet?
1- T-joint, bevel-groove
2-Corner joint, bevel-groove
3-T joint, v-groove
4-Corner joint, V-groove
For pipe Flange, our inquiry has been A350LF2. Vendor suggested A105N/A350LF2. Can you help me what is this dual material? Does it cover requirement for A350LF2?
