Hello everyone,
I have a large assembly and I want to run an interference check on. The run time is fine and it completes in a few minutes. My question being, is there anyway (at the part level) to set a specific part as "ignored" so the interference detection does not pick it up. I am having...
Hello everyone, hoping someone could point me in the right direction. I am currently aggregating all possible information regarding clearance hole sizing for a fixed fastener calculator. See image below.
All of the values in the tables are based off ASME B18.2.8-1999 which can also be found...
Good afternoon fellow engineers. I had a quick question regarding the contents of this drawings GENERAL NOTES. I want to know if anything that I defined in the general drawing notes directly violates anything withing ASME Y14 Standards.
Every part will be sent to a manufacturer with a STEP...
Good afternoon everyone! Hope everyone is well!
I have a question regarding what is allowed on a continuation page. Am I allowed to have a "General Notes Block" like I would have on the primary / first page? With that said, do all flag notes have to relate to the first page or can I have a...
