hi everyone
i'm trying to build a reverse gear event such as fishhook with the vehicle going backward or J-turn with the vehicle going backbard (in reverse)...
would you please help?
thanks a lot by the way because of many helps i have received in this site
hi everyone
thanks for helping a lot when needed
i have made a twist beam suspension model assembly on a testrig and when i get a test when performing it on the wheel centers instead of the contact patch, i get this error:
Static equilibrium analysis has not been successful.
The maximum...
hi
i'm trying to optimize the front suspension bushing stiffness constituents in a full vehicle model in adams/insight?
when i look into the factors of the said bushing i can't see the stiffness factor. the image is as below:
how can i do that?
how can i optimize the bushing stiffness or...
hi
i tried to edit some of the data in the engine property file model in notepad and i started getting this message...
the problem is that i had saved the original file and i'm getting the same error from the original file...
please help
the error is as follows:
Reading in property...
hi
i have changed the steering column joint from hooke to convel and i'm getting an additional 0.5 degree initial steering angle in every test...
can anyone help me with this?
what is causing ths?
thanks everyone for helping a lot
hi
i intend to find out the wheel angle of the vehicle model in Adams/Car while steering in a subsystem assembly and a full vehilcle assembly, by defining a request...
how can i do that ? what parameters do i need for defining that request? what is the best way to do that?
appreciate your help.
hi
i saw a parameter variable once when i was perusing through an engine model and i saw a parameter with which you could determine the number of engine mounts in an engine model... i'm not sure if it was a parameter variable or something like that...
i was wondering if i could change the...
hi
i haven't been able to measure the wheel angle when the steering wheel turns... couldn't find the parameter in postprocessing..
can anyone help?
thanks a lot
hi
as soon as i enter a flexible body into adams/car i get this error:
Reading in property files...
Reading of property files completed.
Setting up the vehicle assembly for Driving Machine maneuver...
Setup of vehicle assembly completed.
Simulation is beginning...
Starting analysis #1 of...
hi
i have modified steering a default Adams/car steering model and i get a steering test in a front suspension model...
the parameters are normal, the suspension has no problems when i tested it separately.
when i modify intermediate shafts hardpoints to the location of the vehicle model, the...
hi
i have modified steering a default Adams/car steering model and i get a steering test in a front suspension model...
the parameters are normal, the suspension has no problems when i tested it separately.
when i modify intermediate shafts hardpoints to the location of the vehicle model...
hello
i'm trying to eradicate the symmetry characteristics of hardpoints and some other parts in Adams/Car and Template builder...
i can't find where to do this ...
would you please help?
thanks
