hello Team,
Could you please explain me how to Interpret OZ (Unspecified Linear tolerance zone Offset (Offset Zone)modifier as per ISO GPS with example.
Any Sketch to Understand better way with Application wise
Hi Team,
I pasted below picture, This is revolved profile pasted only a revolved section and this is sheet metal of 1mm thickness circular profile with section like this.
My question is on Blue marked Profile tolerance, where we have profile tol. 0.5 with respect to A,B,C but i have size limit...
Hello Team,
From the picture inserted, I have a situation that i want to show next to datum A , or Datum B callout that Datum A or B is restricting only 2 or 3 or etc. Degrees of freedom in ISO GPS system.
Do we have any method in ISO GPS system to identify like that?
Hello Team,
I have one doubt regarding composite position tolerance- Inserted picture.
This is an Assembly where Datum A & Datum B is at inlet side and I shown picture at only other end where we can see Datum C is applied to one of the stud in the flange.
Other single stud is controlled with...
Hello Team,
I have a question on the attached picture. CAn I make Datum "A"(Dai. 40) as MMB to get DAtum Shift to facilitate Assembly of bigger Diameter (Dia.90) with counterpart during Assembly?. This is Sheet Metal part.
Hello Team,
I have a question on the attached picture. CAn I make Datum "A"(Dai. 40) as MMB to get DAtum Shift to facilitate Assembly of bigger Diameter (Dia.90) with counterpart during Assembly?. This is Sheet Metal part.
Hello Experts,
Can you explain me with calculation how translation modifier is helping with and without translator modifier according to ASME y14.5 FIG 4-19
https://files.engineering.com/getfile.aspx?folder=ba0c2b74-a024-43a2-8b49-5a746b25b35d&file=Translator_modifier.PNG
