I work with several large pressure vessels. In operation, the vessel lids are removed and heavy tooling/materials are placed into the vessels (similar to a composite autoclave). I am not a pressure vessel engineer, but I am very concerned that the stresses applied by the tooling are not being...
I am seeking to angle a tolerance zone for a hole and extend it in that angled direction. For my purposes, the angular requirement is fairly tight, while the length requirement, not so much. The hole is being mated to a slot with a dowel pin. This is not my desired choice of frame, but it must...
I read this article by Bill Tandler and thought it was very interesting, but I wasn't satisfied with the solution.
https://go.gale.com/ps/i.do?p=AONE&u=googlescholar&id=GALE|A328422062&v=2.1&it=r&sid=AONE&asid=fb82bcc4
With a linear slot that is aligned with the datum reference frame, would it...
I am trying to get a series of holes put into a plate. The holes themselves must be reasonably perpendicular to the surface to allow for adequate bolting as they are threaded holes. The translational positions on the plate are not critical and they are not related to each other in any way. I...
I'm working through something funny. I've got a long extruded rectangular (slightly off square) prism that is symmetric in X/Y/Z. I primarily care about the rectangular ends being perpendicular to the long sides and parallel to each other as these are measurement locations. I utilized two of the...
