Hi,
I have an axi-spymmetric model. I want to apply elasto-plastic material properties in the first step and elastic material property in the second step. Is there a way to do it?
What I did is, while defining the material properties, I have given the plastic properties only at 20 degrees and...
Hi
I am doing Ratcheting of a pipe bend in Abaqus.
I have cyclic stress-strain curve data.
I have given the data as shown in the attachment.
But what hardening should I select and should I give any suboptions? I have no other data other than the cyclic curve.
To my knowledge, the cyclic curve...
Hi,
I want to give half-cyclic curve properties of a material to get the plastic behavior of the component during cyclic loading.
I have the values of stresses and strains as shown below
0 0
25 0.010973478
50 0.022751482
75 0.036091362
100 0.051730571
125 0.070394475
150 0.092799677
175...
Hi,
I modeled a pipe bend, pressurized it, and gave a displacement. I want to plot the stress-strain curve for the maximum stress location. It is an elastic-perfectly plastic model, so I have plastic strain as well. To plot the stress-strain curve, I have taken the von-mises stress and (Emax...
Hi,
I am new to creep analysis in Abaqus.
I understand that I need to go to materials->plasticity->creep->select user subroutine.
What should I do after that?
1. How to write a subroutine?
2. If I have a file where a subroutine is written, where should I upload in Abaqus Standard?
Thanks in...
