Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. S_S_IBRAHIM

    Heat Shrink

    My question is about Heat shrinks method used in covering control wires for indoor installations , is it an acceptable standard method according to Canadian Electric Code ?
  2. S_S_IBRAHIM

    Subtransient reactance of induction motor

    How can I know the subtransient reactance for an induction motor if it is not mentioned in the motor data sheet ?
  3. S_S_IBRAHIM

    Recommended starting methods for LSPM motors (Line Started Permanent Magnet)

    DO these types of motor (Line Started Permanent Magnet ) can work efficiently with VFD ?
  4. S_S_IBRAHIM

    Ground Check Zener Diode

    Hi all collogues, We are installing a 5.6 volt Zener diode connected to ground inside a junction box of a motor for GROUND CHECK purpose , this Zener diode has its own wire inside the power cable ( GC wire )and then this wire should be connected to a ground fault monitoring relay in the...
  5. S_S_IBRAHIM

    Calculating start/stop time for induction motor

    I need a simple formula I can use to calculate the starting time for induction motor to be set up into VFD parameter in a correct way not random selection
  6. S_S_IBRAHIM

    CRN-TSSA Ontario Canada

    A lubrication system for pumps using oil working pressure = 35 psi , does it require CRN ? in which category the oil can be exempted / classified as per the technical standard and safety act ? as Hydraulic fluid ? or oil for non-fuel application ? or liquid not more hazardous than water ?

Part and Inventory Search

Back
Top Bottom