I've got a ASME Div 1 pressure vessel that needs to be designed for relatively low pressures (+10 psig to -2 psig, @ 275 deg. F) and I have a question about a flange that separates the cylinder from the F&D Head. The image below shows the location, so they would be able to pull the whole top of...
Good afternoon all,
Has anyone been able to model a vacuum relief valve in the software AFT Arrow? I have several tanks that will be connected to a vent header line and wanted to show a relief valve opening up if the vent header line vacuum level went below the relief valve set pressure.
The...
Hello All,
We are looking at a process line from the bottom of a pressure vessel to the suction side of a PD pump. Here's a snapshot of the stress model. 20" OD vessel, 6" piping, reduces down to 5" pump nozzle. You can see the vessel at the top anchored from it's support lugs, and the PD pump...
Hello All,
I am looking at some steam turbine-driven pumps in a paper mill/recovery boiler feedwater application and have a few questions about the inlet and outlet piping.
The original system from the 60s/70s had spring cans on both sides and a whole host of supports that had been...
I've got a sketch attached showing the layout and dimensions, it's a steam PRV with the discharge piping routing down to the ground level instead of exhausting upward. I'm not used to seeing a relief line routed like this so I just wanted to make sure I wasn't missing something. Are there any...
I have a case where a truck is loaded with a liquid product, and the vapor displaced during the fill is routed to a thermal oxidizer. A bunch of tank and truck unload station vapor lines tie into a header leading to the thermal oxidizer.
There is a discussion about whether a blower is needed in...
