Hi everyone,
I'm pretty sure I know the answer to this, but just want to double check here.
Take the example image above, and you're asked to measure true position of all three holes, with respect to datums A | B | C.
The first hole from left edge will have position measured with .500 as the...
Hi everyone,
I have a situation where the only way to weld two pieces together while also be self-locating is having holes run through both parts, and have the welder run a pin through both while welding the rest of the edges.
Then I would want the welder to remove the pins after weldment, and...
Hi everyone,
I have designed thermal pad cutouts for their particular components. These will just be laser cut to shape from .006" stock rolls and then applied.
Because of having many variations, is there a blanket method to assign all cutouts the same profile tolerance without specifying...
Hi everyone,
I have an application for which I'm using plastic washers (delrin or nylon) to prevent dissimilar metals corrosion between an AL plate and SS fasteners in a marine environment.
I'm being asked to stack SS washers on top of plastic ones.
Are there standards or references that...
Hi everyone,
I'm hoping someone else has come across this issue before.
I'm dealing with an issue where with feature control frames, the leader is attached to the center of the frame (bottom of screenshot) rather than the top or bottom edge of the frame (top of screenshot).
I cannot find the...
Hi all,
I understand how TP tolerances are distributed by the difference in MMCs in reference to Y14.5 appendix B (fixed fastener/floating fastener conditions).
When it comes to bidirectional tolerancing for slotted holes, I can speculate that you can apply those formulas to the narrow width of...
