Hi!
After a discussion with a vendor. Does any of you have a specific requirement how to transport a PRV? The question should be relevant both for new valves from manufacturer as after re-calibration in repair shop.
From my knowledge the practice have always been that PRVs shall be transported...
Sorry if this question have been asked before, but couldn't find anything.
I have a question if PSV should be tested with Nitrogen or with Air.
A new test workshop for recalibration of PSV shall be made on an installation on the Norwegian Continental Shelf covered of covers by European...
Hi!
Thanks for the tip to even try in this forum as well as in the other Mechanical Engineers-Valve Engineering.
A safety valve have a set. pressure of 290barg. When loading the actuator on top of the PSV with instrument air, the set. pressure is increased to 310barg. This is done by three...
