So i was reading about this topic and I found this
"Figure “A” below shows an ideal configuration of piping, in which the piping distance between each nozzle is minimized. In the case of hot oil piping, differences in expansion occur between the suction piping of pump A and that of pump B...
Is there a reason why clamp in shoe support are welded like in the picture? ( I mean like the clamp sides where bolts are attached are not in the same line or elevation)
Which one is better to use for a pipe which has a length of about 300 m .
I remember using T support in one of the projects but the client asked to change it to sleepers , so is the advantages of sleepers over T support and when to use sleepers and when to use T supports?
In weld neck flanges we specify the facing of the flange for example raised face (RF) and based on that we use a specific gasket to match the facing of the flange
What about lap joint? In autocad plant 3d I can only find Flat face (FF) in the catalogue is it true?
I just read that we can't use hanger supports when dealing with two phase flow piping. is it true? if so, what are the recommended supports used in that case?
