I am reviewing roof framing on a modular home. They used 1 1/2 x 2 1/2 struts to support the rafter and this lands a 2x3 that runs parallel to bearing wall below, but falls on top of 2x6 x10" tall stub posts that project up from the ceiling joist (built with tooth plates). The main issue is...
I typically evaluate roofs in CT which uses IBC/IRC and has a Supplement listing town by town ground snow load and wind speed. Additionally, even if computed flat roof snow is less, there is a 30 psf minimum.
It appears PA does not provide such a comprehensive listing but requires individual...
I have observed a 10' high walk-out basement foundation wall/dividing wall between two condo units. The concrete was poured around 10/06. The wall terminates at the rear exterior (walk-out side) which is stud framed on frost wall. The lower 2' of the separation wall has a 2'x2' diagonal...
