Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. tman0013

    NPT pipe sizes for mertic tool

    Thanks, I'll check it out.
  2. tman0013

    NPT pipe sizes for mertic tool

    I was given a task to measure waterlines of a mold tool and instead of using NPT, use the metric equivalent. Am I safe to assume that NPT refers to the fitting and that the size of the line is actually NPS which means the metric equivalent would be DN? Eg. 0.4375in is 1/4 NPT but really 1/4...
  3. tman0013

    Exporting a SINGLE Jt file using NX6

    It was either that I was not checking in the drop-down to make sure my saved setting was selected or I needed to restart UG. It worked this time. Thanks so much for the feedback.
  4. tman0013

    Exporting a SINGLE Jt file using NX6

    I did this and found one very close to what I needed to know, however the problem was apparently solved with the "As a Single File" solution as the thread ended at that. I'll keep looking though. Thanks
  5. tman0013

    Exporting a SINGLE Jt file using NX6

    I was asked to do a task at work involving exporting a single jt file. I was instructed, and followed up by internet, that by choosing "As a Single File" under the JT preferences before exporting, would give me one JT file. Instead I seem to get the same result as if I had never changed the...

Part and Inventory Search

Back
Top