Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. FredFlatstone

    Square bar through bearing?

    Yes, perhaps you are correct there Mike! [bigsmile] I'm not too well versed with MechEng so wasn't quite sure. Thanks for your input.
  2. FredFlatstone

    Square bar through bearing?

    I have a project that calls for an 8mm rod through a number of bearings. The bearings use a set screw, which means that ideally a flat edge is called for to give the set screw something to hold to. I'm wondering, rather than go through the extra machining costs, could I use a square bar, or...

Part and Inventory Search

Back
Top Bottom