Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. AKVS24

    p-h chart for refrigerants

    In p-h chart for all refrigerant,why the pressure vs enthalpy curve doesnot start from zero pressure ?
  2. AKVS24

    chiller evaporator temperatures

    In the evaporator of a chiller,why are temperatures 7/12 deg C mentioned for water,instead of 6/11 or 8/13 ?
  3. AKVS24

    Viscosity correction for liquid

    What should be the minimum viscosity of pumping liquid to use Viscosity correction chart?What is its significance?
  4. AKVS24

    Effect of solids in pumping liquid

    What is the effect of solids in pumping liquid.i.e effect on impeller selection,wear rings and seal flushing plan selection.
  5. AKVS24

    Pump speed selection

    How is the pump speed selected?What is the effect of selection on NPSH required?
  6. AKVS24

    Boiler operation

    Can a 10 TPH rated capacity boiler operate at a load of 2 TPH?
  7. AKVS24

    Piping supports

    For a pipe what is the minimum length of pipe at which the pipe supports are to be placed?
  8. AKVS24

    Motor efficiency

    What is the reason for efficiency of IE3 motors to be greater than IE2 motors?
  9. AKVS24

    Pump MCF

    If a pump has a maximum flow of 60 m3/hr & Minimum continuous flow of 10 m3/hr. Can the pump be operated at a flow of 5 m3/hr ?
Back
Top