Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Prima Domino 16ga SS
I agree with Foostrap, your feed rate seems extremely low for your power setting. The 2500 watt trumpf 1030 i run cuts 16 ga ss clean at 275 in/min and 10 bar, -2.3 mm focal point, 1 mm standoff. You should be able to get at least 325 - 350 in/min with your 3500 watts. Also, why are your...- OSMourad
- Post #4
- Forum: Laser engineering
-
SS cutwith Oxigen
Hey all. In my experience it's best to cut stainless with a nitrogen assist, i find that even shop air comes out cleaner than oxygen. If you're having problems with vinyl bubbling up try reducing the gas pressure or lowering the power. Lower gas pressure makes it so that the gas only removes...- OSMourad
- Post #16
- Forum: Laser engineering
