Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. JuKnip

    Step by step on keywords

    Thank you all for your help!!!
  2. JuKnip

    Step by step on keywords

    Good morning to all, I just would like to know, since in others softwares there's the possibility of running the algorithm step by step, does that possibility exist in ABAQUS? So I could run each line of the keyword on my command and analyse where the error occurs. Thank you all
  3. JuKnip

    Unexpected Error 193

    I tried creating another file .cae, and now, when I submit the job, I get the error: Error in job SC1NDC: The executable C:\Program aborted with system error code 65533 I'm searching on the internet, but no luck.
  4. JuKnip

    Unexpected Error 193

    Hello to all, This was the first time that happened. I ran a job, that aborted a while after, then I tried to open the monitor to read the status file etc, but Abaqus crashed down and turned off. It only happens with any job (I created others to test it out) of a specific model (I even created...
  5. JuKnip

    ALE adaptive meshing

    I believe I have understood the problem, but now it's about the results: in each frame there's not the moviment of the workpiece (it has the boundary condition velocity). On the first 10 frames there's no moviment, and suddenly, on the next frame, the tool appears in the middle of the workpiece...
  6. JuKnip

    ALE adaptive meshing

    Hello to all, I'm a beginner in ABAQUS and I'm trying to simulate micromilling in 2D on ABAQUS (6.10). Since it has large deformations and loss of material I opted using ALE adaptive meshing on the workpiece. I created the domain, but I'd like to create a Eulerian boundary region(line in this...
  7. JuKnip

    milling one piece made of two different materials

    When I submitted the simulation, it was like the first partition (which was one material) pushed the other partition breaking it, like they were different parts and they weren't connected even by the mesh. I was expecting that the first partition would deform and push the other partition with...
  8. JuKnip

    milling one piece made of two different materials

    hey guys, I'm having a problem here and I hope you could help me. What I'm trying to do is a 2D micromilling in ABAQUS Explicit. The geometry of the piece is a rectangle, and it'll be deformed by the tool. The thing is, I created partitions on the piece to associate each partition to a...
  9. JuKnip

    ABAQUS/Explicit - Contact Noise

    Well, I'm modeling two pieces of the same material. The pieces are positioned so that one is inside of the other (There's a picture with one of the contacts highlighted). The actual problem is that when a uniform pressure is applied on the piece inside (like pushing it down), it slides to the...
  10. JuKnip

    ABAQUS/Explicit - Contact Noise

    I changed the surfaces master-slave, but it didn't change a thing. So, I really don't know how to decrease the noise or if it's the cause of the oscillation of the internal energy.
  11. JuKnip

    ABAQUS/Explicit - Contact Noise

    Hello people, I'm a beginner in ABAQUS (learning since april) and I have a problem with contacts. I'm using surface-to-surface contact with two pieces, the one deformable being the slave and the other being the master. I'm always getting the warning "The slave surface nodes have much larger...

Part and Inventory Search

Back
Top