Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
interference fit shaft spline
mfgenggear, We are sending out a replacement shaft in an application where the shaft hangs vertically from a hub. On previous design, hub was threaded onto shaft and 4 holes were drilled and tapped parallel to shaft axis at the hub/shaft interface, with set screws inserted to act as keys. Set...- brian823
- Post #8
- Forum: Gear and Pulley engineering
-
interference fit shaft spline
gearcutter, Would the tolerances in the chart you provided be applied to the space width and the tooth thickness?- brian823
- Post #5
- Forum: Gear and Pulley engineering
-
interference fit shaft spline
I am trying to find information on designing an interference fit involute spline. Should it be a side fit spline with interference where the teeth contact each other? Or should it be a major diameter fit with the interference between the major diameters? Do the standards address the amount of...- brian823
- Thread
- Replies: 13
- Forum: Gear and Pulley engineering
