Thanks iainuts,
The interesting thing to add here for SS316L is:
1. Section II part D of the B&PV code does not rate SA276 (unlike SA479) for high temperature (pressure) applications.
2. The properties of the two specs. are so much alike (only the elongation for certian sizes of SA276 is...
Hi Cory,
The requirements I have to meet are (identical to the investment cast version with alloy A356 T6 per B618):
1) No design changes if possible. Is it achievable?
2) The enclosure is to be rated to take 4x explosion pressure (of 800 psi), i.e. the die cast alloy should have same or better...
Hello All,
I have been given a task to change the process of manufacturing of a cast aluminum enclosure from investment casting to die-casting.
1) Can someone pl. suggest me a die-cast alloy with same or better mechanical properties.
2) Will the change in process be feasible without change in...
Yes it is the exterior of the part. The life of the part to be at least that of powder (polyester) coated aluminum exposed to the same environment. Temp. min. 150 deg C & no pressure concerns. Min./no abrasives in the corrosive atmosphere.
The part is 1 in dia. x 0.5in long plug to seal an enclosure after assembly. The seal assembly involves pressing it into the enclosure, a seal is maintained using an o-ring along the dia. of the plug in question. Hope that this help. Thank-you for your help.
I have a small part (bushing) which is made up of 6061 Aluminum & bright Ni plated. I have seen severe corrosion of the material over time in marine environments. Can someone pl. suggest a cheap solution for the problem... short of replacing the Al. with exotic (& costlier materials).
Thank you...
I have a molded nylon 6 bracket approx. size 7x25x5mm. Can someone suggest alternative materials which could use the same tooling (similar shrinkages) but is a little more flexible?
Thank-you for your help.
Can someone suggest me the with permanent adhesion of valox 357 with female threads (1/2" N.P.T.) to corresponding male threads stainless steel (316??) capable of withstanding high temperature (up to 80 deg C) & humid conditions
Thank-you for your help in advance