I was hoping tunalover would repsond to this as he is the one who gave the example of the tolerance block. I know on the face of the drawing the number of decimal places for the tolerance must be the same as the dimension for inch units. I wanted to know why he thought it was ok to do this in...
This is in regards to a response I saw from tunalover regarding tolerances:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN INCHES.
TOLERANCES:
.X±.1
.XX±.01 (could be .XX±.015 too!)
.XXX±.005
.XXXX±.0005
ANGLES±1º
My question is "could be .XX±.015 too!". Is it permissible to use a 3 place...
