Good morning guys/girls, hope all of you are well.
I am looking for a solution regarding a design I am busy working on. I have a situation where I have to limit the travel between two plates (vertically), but these plates also move slightly in the horizontal plane to. So the “limiting” part...
Good morning guys/girls, hope all of you are well. I have a question - I want to find out the formula to use when calculating the radial expansion of a close ended cylinder under pressure. i have looked around but can only find formulas regarding open ended cylinders.
Your help would be...
Good morning guys/girls, hope all of you are well. I have a question - I want to find out the formula to use when calculating the radial expansion of a close ended cylinder under pressure. i have looked around but can only find formulas regarding open ended cylinders.
Your help would be...
Good morning guys, hope all of you are well. Just thought I post in here to see if anybody has the information i am looking for. I am looking for the maximum allowable thickness of the chrome layer on the CROMAX IH 482 from OVAKO. And also the amount of microcracks per mm^2.
Thanks for the...
[smile]Thanks for the replies guys. It would seem like it is possible from looking online that one can get a really good finish with roller burnishing on cast iron. Will give it another go!!
Good morning guys, i have a question. I am looking to roller burnish a seal groove (inner groove). The part is made of cast iron, and after attempting to roller burnish the groove to give a better surface finish i could not see any difference in the surface finish.
It did show a very smaal...
