Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: mdana
  • Order by date
  1. mdana

    New Company Frustation (SolidWorks Discussion)

    I feel your pain. I just started consulting with a start-up and have run into the same problem. To make matters worse, we have people running SW2012, 2009, and 2011.
  2. mdana

    Using slot as datum on bent needle

    Hi, I'm working on a curved needle which consists of a OD.054 x ID.045 tube with a 90 degree bend. The overall length is around 12". A .020 X .050 slot at the proximal end (opposite the bend and tip)is used to control the orientation of the shaft relative to the bend and tip. I've established...

Part and Inventory Search

Back
Top