If I'll have time and need to continue with this task which is probable, I'll check implicit dynamic analysis too, but as sdebock pointed out for me the coupled temperature displacement analysis worked decently. And yes I was looking for a wide variation in temperature. Practically I had the...
I was not looking for stress results. My main problem/task was related with heat flux and obtained temperatures in transient case. Literally my goal was to visualise temperature differences in macro sizes confirming my expectations which was achieved with the help of the first commenter. (Used...
Othrvise, I don't see your point, feel free to explan, but consider: (use google if not unequivocal)
7. This forum reaches out to engineering professionals worldwide, many of whom are not native English speaking. When responding to non-native English posters, please refrain from disparaging...
Ok nevermind this post, found the solution which I'd call tricky. In a few words all what was needed is a reference point coupled with the part, then add the BC t that point. Also at the coupling uncheck freedoms.
So tried the suggestions a while ago and rescieved encouraging results, but had no time but now to write about it. The most problematic part for me was the proper setting of the time increment. (What worked out for me was: time period 1; incrementation type: automatic; max. number of increments...
Hello
Im trying to make a simulation which is based on a rotating disk, but stuck right at the begining. Made the part then placed it in an assembly (for further tasks), then assigned BC ensnare ZSYMM + added another BC an angular velocity where I created a Csys, but this does nothing to the...
Made the changes as you advised and the temperature results were really that small (but at least there was a real change in temperature), so I revised and adjusted my units and now they are all in SI but the results remain.
Only one thing is not really clear for me with the units and that might...
Thank you for your reply! Your suggestions sounds valuable and I will test them home toight. Also I did not thought that there were any temperature change, just looked on the result animation and saw plain constant blue.
Hello
Found out that I posted this thread in a wrong forum group, hope this is the right place.
So, in Abaqus I managed to create two objects with contacting surfaces, pressed to each other while one is fixed and the other is moving with a constant velocity. The simulation seams fine for...
Hello
In Abaqus I managed to create two objects with contacting surfaces, pressed to each other while one is fixed and the other is moving with a constant velocity. The simulation seams fine for stress results, but at temperature it shows no change at all. I tried some BCs and predefined...