Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Surface contact
Thank you for your response Blas! I am not trying to simulate the rotating motion between the nut and bolt, only trying to see what stresses build up in the corresponding threads. Since I was having so much trouble getting the simulation to completely run using the entire threaded areas, I...- ty313765
- Post #3
- Forum: Siemens: UG/NX
-
Surface contact
Hello all, I am attempting to simulate the stresses experienced in the treads of a bolt and nut. To do this I am running a static analysis in NX 8. I applied the surface to surface contacts in the simulation environment using the automatic pairing option, and fully constrained one end of the...- ty313765
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
