Find attached Sketch for the Sliding Saddle Detail.
Looking forward to your advice/comments.
Thank you
http://files.engineering.com/getfile.aspx?folder=5eedc7df-c20f-4fba-ac5e-e0c844e46385&file=Slidding_Saddle_Details_Sketch.jpg
Hi,
I'm currently in a dilenma as regards design of slidling Saddle for a Vessel.
Vessel Size is 2450mm Inside Diameter by 7900mm T/T Length. Design Temperature is between -46/150 Deg C.
Normal Practice I'm familiar with is providing a sliding saddle anchored into the concrete foundation with...
Hi,
Thanks for your comments, fully appreciated.
I have been supplied with the WPS and Welding map with all the information I need being there.
Warm Regards
Hi,
Thanks for you response. Your assumption is correct, vessel is custom designed.
I have asked and the Vendor would eventually send all the above named documents you mentioned.
However, I am still not clear on the Interpretation of UW-16(e).
"ASME VIII - Division 1, Para UW - 16e says...
Hi,
I am reviewing a vendor document for the design of a vessel. The vesse has a ManWay sized at 24" and I got a little bit confused.
ASME VIII - Division 1, Para UW - 16e says Necks and Tubes Up to and Including NPS 6 (DN150) Attached From One Side Only. Necks and tubes not exceeding NPS 6...
