I'm trying to set some views of I part I don't own in TCE so that I can take ISO snapshots. So I go to orient and try combinations of 30, 60, etc until I get the right orientation. Excuse the word, but this is F^&%$&ing dumb. Its 2016, why can't NX9 show me the current angle/position as I...
So I have a tube and I want to make a flat pattern of this thing but the end of the tube must have these semi curved "fingers" flaring out of it and they have to have a bend on them too. I tried a few things suggested here to create the tube and fingers with the lofted flange command. I'm not...
Yes Shift works.Thanks everyone!.
Just click to select, then click and drag on the letter box, finally press shift and that will take you from moving the box up/down to moving the box with its perpendicular leader side to side. Very nice!
It has been asked before I'm sure. I saw some similar questions but no answer yet. here it goes:
I create a leader. After so doing I can move the datum letter box up and down but not side ways so that its leader line moves or extends. Instead the "stub" moves left or right. Also If I pick the...
