Based on these setup pictures it would seem to me that the vectors are pointing in the right direction.
IRstuff - the reason that this should be the same condition is because Ansys allows you to select multiple faces for one inlet boundary condition. So instead of creating a second boundary...
I would appear I didn't explain the setup quite clearly enough. For the top case I have two inlet boundary conditions (one condition for each face with an arrow pointing in) set up at 20 psi each, and a mass flow rate of 83.4 lbm/s. The lower case has one inlet boundary condition (one condition...
I am relatively new to working with CFD, and I have been learning through trial and error with Ansys CFX. One of the things that I have been trying is to compare multiple input definitions to the identical single one. (two physical inlet locations; once defined with both faces on the same...
