I have a customer who uses only air to cut all materials upto 10mm thick. compressor is 16bar, dedicated for only laser cutting. extreme filtration to make it as clean as nitrogen and moisture sensors that shut down the laser source if there is any moisture detected inside the air.
This is on...
HI,
Customer has purchased an old Fanuc based laser with a Facit N1050 NC-Feeded and the message appears on the screen "Load System Disk". Does anyone have a copy of the system disk and instructions on how to load it. I know it is a long shot but hoping someone can assist.
Have seen them used a lot to round the edges of parts to make painting or plating easier. They will not remove burr edges simply make it not so sharp but will still be there. Is a cheap alternative to something like a lismac or webber edge rounding system.
Stainless steel parts still get the...
