Hi Little inch,
Thanks for your input.
3) I actually have found another drawing and will upload later. So if we weld the same way as in the first attachment, are we just getting effectively a flat bar anyway because it's only welded on one edge with the other one cut and not really doing...
Hello all,
This is something that has bugged me for awhile and I don't know how to tackle the issue so any inputs would be most appreciated.
We have identified a number of cases where we may have vibration issue. Any local drain and vent points that comes off those systems will need to be...
Thanks all,
On the outside weld, the leg length / thickness should surely need to be verified by designers? (Can someone answer this?)
I showed my drawings to one of our inspectors yesterday and he confidently replied that the thickness of the outside weld was ok. He added the drawings must...
Thanks racookpe1978 (how can I tag people when I reply?)
If you look at ASME B31.3 Figure 328.5.2B, it does call for higher than thickness weld size.
I have some cases where the weld size is below the pipe wall thickness. Not sure if they are acceptable...[sad]
Hello all,
I have a questions and I am hoping some of you will have an answer....
We are using a lot of slip on flanges on our cargo oil lines (Consider our facility as an oil shuttle tanker). According to the building specs, we have both front and back weld (front being welded to the hub and...
Hello all,
I have been an anonymous user for some time and I have always found this website full of good information. So here I am tonight joining as a registered member. Hope to have many interesting discussions with you all in the years to come.
Actually, the reason I signed up tonight was...
