Hello,
I have a solid model - a half of cylinder. Inner surface of cylinder is loaded with constant pressure (general static analysis). Material is defined as hyperelastic. When i run the simulation, next warning appears:
There is zero VOL. FLUX everywhere in the model based on the default...
Hello,
Does anybody have any experience with the following error:
Quadrature Errors in Pressure Poisson Equation - Element(s) severely distorted. Possible diagnostics are: (A) Check the quality of the elements in the mesh to see if they confirm to the element type specified. It is possible...
I've used partitions: i defined cutting planes, partition face-sketch (offset curves for narrowing part - i create outer and inner (core) section)...i've tried to use swept/structured technique, as mentioned before. But i still have problems with some areas - where the 'curvature' is large...
Hm...about meshing the core using a swept mesh and structured on the outside - my opinion is, that this is one possible option. For example, such technique is also used in Abaqus Documentation, Getting Started with Abaqus: Interactive Edition, Flow through bent tube. This is in version 6.12. I...
Hello guys,
I have a question about meshing cylinder parts in Abaqus. I know, that for these problems, commonly use practise is next: use of partitions, core is meshed with sweep meshing technique and outside cells with structured technique (seeds are concentrated near the wall). But this is...
