The measure distance -tool on Inspect tab has a filter where it snaps by default (center and end point, end point, tangent, midpoint etc.) It used to be on "all" by default, at least in ST4. Now I'm using ST6, and the default selection is center and end point.
I use this tool very much for...
Hi carlharr,
I attached a picture of case what I meant. On picture I've placed points on the middle of the line (which was actually faster than drawing the reference line, didn't thought of that, thanks =)
That could be done without any extra work in SE but it's fine, I'll try to adapt...
Hi Kapil,
Thanks for the video, that was very helpful.
The motive behind the decimal separator is just speed and user-friendliness. Very often I need to input decimals after the numerals when using CAD ie. 2,5. And numeral input is much faster and easier to do with keyboard numpad and the...
Hi,
I've been using NX8.5 with TeamCenter few weeks now and I'm off to good start but I have a few questions:
When sketching for example basic rectangle, I'm used to position it on the sketch using centerlines of the curve. For example in Solid Edge, the dimension tool is able to snap on the...
