Thanks, yes I realize now that I need a mechanical break. Problem with the one I put in the link is the table utilizes both shafts of the motor so this break would not work. Is there any other options?
*update I now have it configured to stop using a relay to remove the jumper from STF to SD. Is it possible to then apply the DC injector break after the prox switch is on? As the motor coast down it passes the prox switch. At that time I would like the injector break to come on and hold the...
The motor only spins in one direction. It is geared down. With a breaking resistor my understanding is this will just help the table stop faster. Is this accurate? I need the table to stop and then stay in the horizontal position. I am looking into DC injection breaking now but I am...
I am performing a durability test on some vehicle components. I have a Teeter-Totter table that is cycled using a 408 motor. For controls I am using a Mitsubishi D700 VFD with a 24 volt 3 pole control relay interrupting voltage between the VFD and the motor. This cycles twice a day for 70...
I am performing a durability test on some vehicle components. I have a Teeter-Totter table that is cycled using a 408 motor. For controls I am using a Mitsubishi D700 VFD with a 24 volt 3 pole control relay interrupting voltage between the VFD and the motor. This cycles twice a day for 70...
