Hi,
I am trying to mesh an impeller however I'm having trouble trying to figure out the correct procedure for this. Would anyone be able to recommend how I should be meshing an impeller, the cone shape and perhaps the fins..
Regards
I have a rectangular model consisting of an input and output (353K input, 303K output). Inside the rectangle is phase change material with a melting temp of 46C and solidification temp of 43C.
When I run the model the melting begins but never completely melts to the other side, I initially...
I have a simple problem of a steel bar with a fixed constraint at one end with a tensile load at the other end. I have meshed and applied loads etc. I can solve the model and no error messages are sent through, however the results won't load. I have done some scouring of this problem and found...
Hello,
I am currently simulating an engine with working pistons, camshaft,rocker arms etc. The problem is that I have set the simulation to run for 30 seconds with 300 frames. This was working for the full 30 seconds but now it is only working for 5.9 seconds and is stopping.
Does anyone know...