Please let me know about the relevant card for the definition of temperature dependent properties of a material in NX Nastran( At each temperature, I need to define the curve for True stress Vs Plastic Strain to define the material non-linearity ).
Is there an option to write that card through...
Please let me know about the relevant card for the definition of temperature dependent properties of a material in NX Nastran( At each temperature, I need to define the curve for True stress Vs Plastic Strain to define the material non-linearity ).
Is there an option to write that card through...
Please let me know about the relevant card for the definition of temperature dependent properties of a material in NX Nastran( At each temperature, I need to define the curve for True stress Vs Plastic Strain to define the material non-linearity ).
Is there an option to write that card through...
I am trying to solve a model with the following degrees of freedom for SOL601.
M O D E L S U M M A R Y
NUMBER OF GRID POINTS = 669592
NUMBER OF CBAR ELEMENTS = 362...
Please let me know about the relevant card for the definition of temperature dependent properties of a material in NX Nastran( At each temperature, I need to define the curve for True stress Vs Plastic Strain to define the material non-linearity ).
Is there an option to write that card through...
Is there any option to use PARAM AUTOMPC in SOL601? The current model contains large no of double dependencies, and PARAM AUTOMPC works fine in Nastran solvers..but with SOL601, I need to correct all the 1d connections..which will increase my task.
Is there any option to check the double...
I have submitted a contact analysis using SOL601 from the Graphics window of NX CAE.And I got the following error and the run comes out. I have been pasting the corresponding log file. Please guide me.
NX Nastran V8.1 (Intel64 Family 6 Model 47 Stepping 2 Windows Server 2008 R2 Service Pack 1)...
I need to perform a contact analysis using SOL601 of a screw thread. But the Cad model is not proper and there are interferences/gaps between the surfaces. It has been meshed as per the geometry and hence, I have been getting unusual behaviour of screw threads. After viewing the result, I got...
Hi,
The attached window is the nastran64Lw.exe. I need to fire the run through this window. I need to define the memory, no of processors and scratch in the optional keywords section.I know the commands, but I could not give it in the Optional keywords window in proper syntax. Please guide...
Thanks for your reply mrfemap. However, as per my observation, there are no peak stresses observed due to the enforced displacements applied on the cut edges. But as a whole, the stresses on the entire cut FE model are exactly 10 times the stresses reported at the same region during the analysis...
[/indent]I have a complicated FE Model of a box type condenser with large no of DOF for static structural analysis. It has been solved in NX Nastran with all the loads to get the displacements and rotations through out the model.Then, the required portion of the model(design area) has been cut...
