Ok, I think I got the .bat file part. The .bat file is supposed to be a file with a command that runs ABAQUS and the desired job.
The question now is, as you already pointed out, how do I extract the desired output values (Temperature vs. Number of elements)?
Is it possible to run manually...
Hey Greg,
How do I get this .bat file? It seems to me that the abaqus job file have either .inp or .odb extentions.
Also, I found a code that supposedly works with abaqus. How do I integrate the richardson extrapolation code with the abaqus code? (By making my function f(x) being the abaqus...
I used the matlab function that I got from the wikipedia page, but unfortunately it didn't work. The function that runs ABAQUS however, how do I know which function it is?
Thanks again for your input and for helping me out, Greg!
Thanks for the link!
I was recommended using the richardson extrapolation to get the optimal number of elements for the mesh. Do you happen to know how somehting about this method?
Regards,
DPeixoto
Thank you for the advice Greg! I'm not sure how to do the error analysis though. Do I have to perform the error analysis on MATLAB?
I already ran a set of analysis and came up with a temperature vs. no. of elements graphic!
Regards,
DPeixoto
Hi everyone,
Although I just signed up, I've been reading posts on this forum for a while now and I've found them quite helpful! Hopefully you guys can help me just as much. I am performing a thermal analysis on a set of cork-core sandwich panels with aluminum facesheets in ABAQUS. The sandwich...
Hi everyone,
Although I just signed up, I've been reading posts on this forum for a while now and I've found them quite helpful! Hopefully you guys can help me just as much. I am performing a thermal analysis on a set of cork-core sandwich panels with aluminum facesheets in ABAQUS. The sandwich...
