Search results for query: *

MintJulep - The perforated sheet is attached to the solid sheet using fasteners (see the attached image). dhengr - I didn't mean to come across as if I was expecting the forum to do all of the work for me. I am just trying to get some experienced opinions about the problem at hand. Maximum...

Ok. What if I wanted to fasten to a solid sheet metal face instead of perforated? I am new to most aspects of sheet metal design...

I have a layered, vertical panel as follows: solid 18ga steel, 2" fiberglass insulation, perforated 22ga steel with 25% open area. I would like to fasten load-bearing parts to the perforated side of this panel, but am an unsure on how to determine the number of fasteners needed? Is this even...

Thanks for the help/tips. I should have what I need!

I need to select a coil for a face and bypass system, but am new to F&B. This is more of a general question than for a specific job, so I was wondering if anyone can advise on an effective approach to sizing coils for face and bypass systems? Thanks!