Hi,
I'm now working on simulation of initial bending stress on cross-section of beam elements. According to my understanding of user subroutine, i.e. SIGINI, can be used to do that. I developed the following codes which I though should work wel. However, the command lind, i.e. IF (NPT.EQ.3)...
Hi,
Sorry for my slip! The following parameters denote the basic geomegry properties of the pipeline and some misc. parameters of elements of stiffness matrix as shown below. I commented some of parameters by using dummy values instead, in order to test what trigered those errors mentioned in...
Hi,
Attached are the input files, as well as the use-defined subroutine I prepared. Some error messages popped up as shown below. Could you please help check what's ('re) reason(s) to such errors? Many...
dhengr:
Thank you so much for your prompt replies! I'll try your suggestions soon. The reason why I raised the previous question is that I'd like to simulate the wound deformation of flexible pipeline during offshore installation. I thought that the wound deformation might be due to the release...
Hi,
I'd like to apply torional strain over beam section (beam element) as an initial condition. However, according to ABAQUS's user manual, there is no such option for beam element. I'm not sure whether I missed some points in the manual. So, I'm writing this message for your suggestions and...
