Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. tomsmith01

    Minimum bend flange width (not length) for mild steel (ie. ASTM A36)?

    The width of the twist is just 1/2" in two areas with an opening element in the middle. I'm simply searching for a dependable guideline. Consider a compelling case, where the width of curve is a great deal not as much as material thickness, say just 10% of thickness (0.050" wide for 1/2"...
  2. tomsmith01

    Horsepower and Torque needed to raise 15,000 lbs. vertically about 40' high.

    I can let you know as a matter of fact that it is exceptionally hard to figure the real tipping focuses. When it was figured out that these trucks were overhauled by our fork shop despite the fact that we didn't make or check these alterations we went under the examination. At that point they...
  3. tomsmith01

    MACHINING C110 Copper Vs C360 Vs Aluminum 6061

    There are most important and expensive part of metals. Aluminum is quite good than copper.
Back
Top