Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. KarlGarant

    Catia Core & Cavity tool - Main pulling direction definition problem

    Hi everyone, I'm currently trying to use the Main pulling direction definition tool to help me split a model I have. The problem I'm facing is when I try to use this feature I'm getting a completly different menu then the tutorials I've been watching. The feature, when used, only lets me see...
  2. KarlGarant

    90deg multi-section (advice needed)

    Thank you everyone, I finally got it to work with a blend. The problem was that the red line was not laying completely on the surface. I had to cut a little bit out using an isoparametric line making sure it did follow the surface. Then used an extrusion like you advised and everything blended...
  3. KarlGarant

    90deg multi-section (advice needed)

    Thank you everyone, I'm at work but I will make sure to try this tonight when I get back home. I'll keep you posted.
  4. KarlGarant

    90deg multi-section (advice needed)

    Hi Irish Mariner, i should have mentionned I tried using both of those but but blend feature wont work since the 2 sketch are connected. The fill feature might work but I don't know how to make it so the surface starts tangent to the ones I mentioned earlier. Hence I tried using multisurface...
  5. KarlGarant

    90deg multi-section (advice needed)

    I am currently trying to make a 90 degree multri section surface with both sections sharing a corner. Looking at the picture linked in this thread. I want to create a surface tangent to the existing one from the red sketch and finish by being perpendicular to the green sketch. I tried adding...

Part and Inventory Search

Top