Thanks rstupplebeen. I solved this a while ago. All I did was create a partition in XY plane. The part was also converging to a single point at one end. I changed the geometry there and I got the mesh working fine. Thanks for your help!
Hey rstupplebeen. Thanks for the reply. I tried creating a cell with just XY plane as datum plane and the mesh has been created without any errors. However, there was a warning in the Message Area below as shown in the pic attached and I did a Mesh check. The results are shown in the message...
Yeah, I have created offset 0 from XY and YZ planes. I'm trying to use cell partition using datum plane and it asked me to select the cell. I have the selected a cell and then it asked to select datum plane. I selected a datum plane and it says "The cell could not be partitioned. Try using...
thread799-317049
I am trying to mesh a thick walled (with inner and outer radius) hollow tapered cylinder in Abaqus 6.13. But, I'm getting an error "The selected regions cannot be meshed automatically using the assigned element shapes. They must be either be partitioned, assigned a tet shape...
