Hello everyone,
I have a one question regarding flare stack design. We have a flare stack chair supported and we have to design as per ASME sec 8 div 1. if i am doing calculation in Pv-Elite with flare stack option then it will do calculation but flange thickness is more because as per app 2...
Dear Sir,
Please provide me the guidance about the scale factor for wind in Pv-Elite. My client is asking to use 1.1 scale factor for wind in pvelite.
Thanks. http://files.engineering.com/getfile.aspx?folder=da2892d8-faf9-4ebe-94ba-a69588c56745&file=wind_scale_factor.odt
Dear Sir,
Please provide me the guidance about the scale factor for wind in Pv-Elite. My client is asking to use 1.1 scale factor for wind in pvelite.
Thanks. http://files.engineering.com/getfile.aspx?folder=5a9dcfae-1761-4da7-8df9-7d303ccb920e&file=wind_scale_factor.odt
Dear,
How to design pipe leg support base plate with two foundation bolts, because pvelite do calculation for 4 bolts as per Deniss Moss. Please suggest, thanks in advance. http://files.engineering.com/getfile.aspx?folder=4067e9bc-6d7d-47f4-9e9f-d3030c850979&file=PIPE_LEG_SUPPORT_BASE_PLATE.odt
Dear Sir,
Thank you for your support, i have few more questions that are given below. Please advice/suggest the answers since i m new in this, and off course
my design will be checked.
1. Design pressure is given 20mbar(g) and design vaccum is 10mbar(g), it means internal pressure (excluding...
Dear JStephen,
I am new in designing tank as per api650. Please also suggest/advice the following points.
1. If material of construction of tank is titanium than how to select the stress values ( Sd, St ), because table 5.2a does not cover this material.
also min. yield strength and min...
Dear Sir,
I have start working to design a tank of dia 7000mm and height 8000mm. There is frangible roof joint requirement as per data sheet. please suggest the design of tank and if possible please provide any ref. calculation and drawing.
Thanks in advance.