Hi All,
Recently I have been coming across complex grooves (pic attached) of components. It is really hectic to get the gcodes for this because, we have to plan for the cutting tools and look out for collision.
The problem is we don't use standard tools to do this. Instead, a carbide rod is...
@DidierPSICAD
Sure, please find assembly in the attached archive.
Ignore the files inside 'New Folder'
Drawings are there in the following files :
Main Assembly __ASSY3.prt
Sub Assembly Level 1
base_assy.prt
base_frame2_assy.prt...
Hi All,
I have observed that the title block table including the locked cells of the model are coming in the assembly which has this model as drafting annotation. Now in this assembly modelling, when I hide drafting annotations, this goes away, but when I go back to drafting (for the assembly)...
Dear gkravanja, it did not work :-(
Hi DidierPSICAD, thanks for your reply! Could you please let me know how my assembly is wrong ? Also I am using NX 8 and I don't know much about reference sets. By changing the reference set to model, did you mean to change the reference set to entire part...
Thanks a lot for your reply @gkravanja!
But these title blocks are coming up in other low level assemblies also also (My assembly is a multi level assembly). Anyway I'll try this and let you know.
Dear All,
I am new to NX. I am using NX 8. I am modelling a trolley. Modelling is complete. My drawing involves numbering each component to its drawing number. To achieve this I created a common attribute in each part which will have the drawing number. Since each part file contains the...
Dear TGS4,
Thank you very much for your reply. I humbly beg your pardon for my stupid question. Our competitors from another country have been selling div2 vessels (without U2 stamp) using this material. That's when my marketing officials asked me if this is possible. I did go through div2 part...
I am designing a vessel for div.2 using material Q345R. On searching about it, I found that this material is most similar to SA515.Gr.60.
The material has higher minimum yield and tensile strengths than SA-516.Gr.70. On going through a similar question in thread794-349081, I got to know that...
Thanks a lot IFRs for your opinions.
A few more clarifications.
4) So shall I design the opening with 200mm, and then use a reducing transition to fit with the 6" nozzle ? What's your opinion ?
A few doubts regarding API650 Flush type connections.
1) Is it possible to Design a Flush type opening such that the "nozzle centreline" is in flush with the bottom plate ?
2) It is known that heat treatment is required for flush type connections. If a cleanout opening is designed for the tank...
