For "mostly steam injector can be operate not exceed 20bar(g)"is from my opinion followed. I have asked supplier about 4 company. They said their product can't operate over 20bar and I want to heat water to sat.liquid at vessel pressure 60bar. Thank for you suggest
what the importance...
Dear Sirs
I have some problem about steam direct contact heater.
I want to use sat.steam 60bar(g) to heating water from 105deg.C to 280deg.C at 60bar(g) by direct contact in the vessel.
then I would like to use "Steam injector" but mostly steam injector can be operate not exceed 20bar(g)...
Sorry for that link
According from ASME sec.8 div.1 2010edition Fig.UW-13.1(j)
If i use thiner hemispherical head attached to shell and cut back the head.
What is corectly tangent length in this case between
1.The original center line of head which attached to shell before cut back.
2.The line...
Hello I have some problem about thiner hemispherical head attached to shell base on ASME sec.8 div.1
Which is corectly tangent length in this case between yellow line or red line(center of head)?
If you have any reference will be good.
THank for you advised.
Hi, I'm new member for this forum, I have some problem for vessel design.
For vessel design life 25years.
What is the important parameter to clarify them?
and how to calculate that parameter?
(sorry my english was bad)
Thank for you kindness
