I have a single catpart which contains assembly constraints(Coincidence,Surface-Surface Contact,etc.)in it.
I have never seen such a single catpart like that before.
Do you know how to make it?
Please see the attachement.
Thank...
DMU Kinematics-
Watch Stop at clash function Video and
tell me how to stop it at exact clashing point? https://files.engineering.com/getfile.aspx?folder=cdb49436-4a72-4521-b483-f4565a19e06e&file=Medya1.mp4
In DMU kinematics, I want yellow bar to stop at exact clash point with the blue part.
But it doesn't stop, but penetrates into the other.
How to make it stop at clashing point exactly? (see attachement)...
Hi;
I am looking for a command I saw in an assembly. Under 1-Product there are only 4-CGR files. And somehow without adding any Catpart this guy has managed to add an Axis to this product. Please see the signe marked with question-mark in my attachment. Do you know this signe or command? How...
In an assembly, I changed some catparts properties as below; Right click-Properties-Graphic properties-Line type-Dotted Lines(or anything). Also Right click-Properties-Graphic properties-Thickness from 1 to 2 mm. In 3D assemby everything looks fine.
I want all new properties I applied in 3D to...
Suppose isometric view's link is broken and i don't have the original 3D Catproduct. So i can't create anY BOM again. I have only BROKEN 2d and i want to attach its BOM table to the available broken view.
Is it possible to attach them somehow?
Hello
In 2d drafting module is it possible to Fix-together the automacially generated Bill Of aterial BOM chart and its isometric view?
so that when I move the View, i want BOM-table to move as well.
How can i Fix or attach them together?
3 Catparts with different Opacity levels in a Catproduct (Assembly Design).
1) 100% opacity 2)50% opacity 3) 25% opacity
In Catdrawing When ı get a front-view I want each part to be shown according to its opacity. (Sharp or Obscure, less obscure etc..). But it doesn't.
How can I do that?
Hello;
In CatiaV5 in assembly design (Catproduct), I have some catparts with 100% transparency and some parts with 50% transparency.
In 2d (Catdrawing), I want to have a front-view respecting transparency level in 3D.
Unfortunately all parts are shown with 100% transparency.
How can I sort it...
Actually I followed your steps one by one but couldn't achieve my goal.
Can you see the attachment and describe one by one from this new example?http://files.engineering.com/getfile.aspx?folder=5ddb1275-01ba-4987-b519-84e04aabcfd4&file=restricted_section_2.JPG
In an assembly environment the parts behind mix up the section view.
In the figure below is it possible to have the section view for only the red rectangular window only?
(Green line: Section center line, Red Window where I want to restrict as section area)
How can I do that...
