Hi!
Currently i'm performing bracket analysis, which is connected to ring with bolt joints. In 1st step of analysis I' am applying bolts preload and at the 2nd concentrated force to bracket via coupling constraint.
I noticed that this steps separately (2nd step with coupling constraints in...
Hi!
To simplify geometry and reduce sim time i want to model bolted joint in another way (without 3d geometry). As i seen here (chapter 4.4) it is possible in abaqus , but i've no idea how to deal with that.
Any example, short step by step tutorial?
Thanks, Kamil.
Hi!
I'am trying to simulate bolt-nut tightening (with certain value of torque) to obtain bolt elongation which will be input for the Adjust length method in Bolt Load in another sim. Actually i've no idea how to do that.
I've tried to use small sliding/specify for single-threaded bolt method in...
Hi everybody,
I'm new in this forum and I've trivial problem in Ansys Workbench. I want to apply force to the center of the hole to simulate pulling a rod which is connected to joint. Earlier I've worked with Abaqus and there I was using reference point which was tied with cylindrical surface...
