Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. sadekbenhassana

    ASME Authorized Inspector NB commission number verification

    AI sign the U1-A form after accepting that a specific pressure vessel is in full compliance to ASME code requirements. How to check the validity of the authorized Inspector National Board commission number?
  2. sadekbenhassana

    Acceptance of Induction Bending of pipe to ASME B31.1 & 3

    Dear all, Induction bending of pipe can replace a lot of welded fittings. Under what conditions the induction pending can be accepted to be in compliance to ASME B31.1 and ASME B31.3? (maybe the answer already exists in a code interpretation!) Regards
  3. sadekbenhassana

    Qualification of NDT procedures

    Yes, i already know requirements of ASME Sec VIII. Thank you everyone for your comments. REGARDS
  4. sadekbenhassana

    Qualification of NDT procedures

    If the procedure qualification of is not a code requirement. Then, i will not keep records and/or documents that demonstrate this qualification
  5. sadekbenhassana

    Qualification of NDT procedures

    T-150 (d) : when qualification of the written examination procedure is required by the [u]referenced Code Section, it shall be qualified .... my question is about those codes sections . Thanks
  6. sadekbenhassana

    Qualification of NDT procedures

    According ASME BPVC (from section 1 to section 12)  where and when NDT procedures qualifications is a requirement (not only demonstrated to AI). Regards

Part and Inventory Search

Back
Top Bottom